Trusted Since 1985

Garbage Disposal Installation Garden Grove

Got a dead garbage disposal? Maybe it hums but won’t spin, or worse, leaks water under your sink. Our garbage disposal installation in Garden Grove gets your kitchen back to normal without the mess or guesswork. Whether it’s a brand-new unit or replacing a jammed-up old one, we make sure it fits, drains right, and doesn’t trip the breaker.

We show up with fresh cords, new putty, and the right flange hardware for your sink. We check for any rusted wiring, cracked drain lines, or broken mounting rings that could cause future problems. Everything gets torqued and tested before we leave. You won’t need to clean up after us, and you won’t be left Googling why it won’t turn on.

Use the online calendar to lock in a visit or call (657) 272-7712 if your disposal just quit. We’ll fix it fast so your sink doesn’t turn into a science experiment.

Replacing a Disposal by Twin Lakes Park in West Garden Grove

We got a call from a guy living near Twin Lakes Park, close to the West Garden Grove Little League fields. His disposal locked up solid and tripped the breaker every time he flipped the switch. He figured it was clogged, but it turned out the bearings were completely rusted and the motor smelled burnt.

He had a new unit already, so we swapped it in that same day. The flange was warped and the sink had old dried putty that never sealed right. We cleaned the area, replaced the mounting ring, checked for leaks, and ran a full test cycle. He said it was the quietest one he’d ever heard. Even got a thumbs-up from his kid who thought it was “cool it ate an ice cube.”

What Happens During a Garbage Disposal Install

First, we shut off the power under the sink or at the panel. Then we unbolt the old disposal from the mounting ring, disconnect the drain pipe, and remove the wiring. If the old flange is still good, we clean and reuse it. If not, we replace it with a new stainless one using fresh plumber’s putty.

We connect the wiring with new wire nuts and a strain relief clamp. Once the new unit is mounted and locked into place, we hook up the dishwasher drain if needed and bolt on the tailpiece to your sink’s P-trap. Then we flip the power back on and run water through it while checking for vibration, leaks, and jams.

Every install’s a little different depending on the age of the plumbing and the model of disposal. But no matter what, it ends clean and tight.

DIY Garbage Disposal Mistakes That Happen A Lot

Garbage Disposal Installation Fountain Valley

One guy used duct tape instead of a proper strain relief clamp. The wires pulled loose and blew a fuse.

Another customer on Orangewood Ave installed a disposal without knocking out the dishwasher plug. It flooded his cabinet every time he ran a cycle.

We even had a homeowner try sealing a leak with caulk instead of replacing the gasket. It worked for a day… until it didn’t.

(657) 272-7712

Need a Local Plumber In Garden Grove?

Professional Plumbing provides free plumbing inspections for current homeowners during business hours. A small fee applies for homes in escrow or for sale, which can be credited toward repair costs if we're hired.

Related Services

Book a Garbage Disposal Installation in Garden Grove Now

Don’t let your kitchen sink become a backup zone. Our Garden Grove garbage disposal installation service gets it fixed up quick, clean, and fully wired. No guessing, no mess, and no wasted time at the hardware store.

Schedule Garbage Disposal Installation in Garden Grove Online.

FAQs – Garbage Disposal Installation Garden Grove

Usually between 1 to 2 hours. It depends on if we’re replacing or starting fresh.

Most fit standard mounts, but some need special flanges. We bring adapters just in case.

Not usually. As long as there’s enough space under the sink, we can install it.

We can recommend an electrician or help you set up a switch if needed.

You can try, but wiring and leaks are common mistakes. We fix DIY installs all the time.

    Request a Quote




    Required Services: